Next, you’ll need to determine the route that your wiring will take. You’ll also need a boat light switch – either a toggle switch or a rocker switch will work fine. You’ll need a length of marine-grade wire, some electrical tape, and a few wire connectors. If you have ever wondered how to wire multiple boat lights to one switch, wonder no more! This detailed blog post will show you exactly how it’s done.įirst, you’ll need to gather your supplies. How to Wire Multiple Boat Lights to One Switch Once it’s mounted, twist each exposed wire clockwise onto a connector terminal on your boat’s existing electrical system until tight (consult your boat’s owner manual or a qualified marine technician if you’re unsure where these terminals are located).Īgain, use electrical tape around each connection point to prevent any moisture from getting in.Īnd that’s it! You’ve successfully wired up your new navigation light. Lastly, find a suitable location on your boat to mount your navigation light using the screws that came with it. Now take your electrical tape and wrap it around each connection point to make sure everything stays secure. Once that’s done, twist each stripped end around a connector terminal on your navigation light until it’s tight (be sure not to over tighten). Next, use your wire cutters to strip about ½ inch of insulation off of each end of all three wires. The “L” wire is for the left side of the boat, the “N” wire is for the right side, and the “G” wire is for the green running light in the middle. The three wires coming out of the navigation light are typically labeled “L,” “N,” and “G.” – 3-pin navigation light (available at most marine supply stores)įirst things first: take a look at the wiring diagram below and familiarize yourself with how everything is connected. Here’s what you’ll need for this project: With a little bit of know-how and the right diagram, you can easily wire up your navigation lights in no time. And if you’re not familiar with wiring, the whole process can seem pretty daunting. If you have a boat, chances are you’ll need to wire up some navigation lights at some point. Now you can easily turn your boat lights on and off with the flick of a switch. Finally, connect the ground wire from the light fixture to the negative terminal on the battery. Then, run the negative wire from the switch to the light fixture.ģ. Start by running the positive wire from the battery to the switch.Ģ. It’s easy to wire boat lights to a switch, and it’s a great way to add some extra safety and convenience to your boat. Mount the navigation lights in their respective holes and secure with screws or bolts How to Wire Boat Lights to Switch. ![]() ![]() Connect each wire to the corresponding terminal on the navigation lights.Run wires from each of the navigation light holes to a central location, such as a battery or switch panel.Drill holes in the boat at the chosen locations for the navigation lights.Choose a location for the navigation lights on the boat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |